4L60E Transmission Swap

Mechanic Shortcuts

2004 Chevy Trailblazer

Transmission swap

Vehicle information- 6 cylinder, in line
Automatic transmission - 4L60e, 2 wheel drive.

Tools required:

3/8 drive ratchet,

1/2 inch drive ratchet,

1/2 inch drive breaker bar,

15 mm socket 3/8 drive,

18 mm deep socket 1/2 drive,

7/16 socket 3/8 drive,

13 mm socket 3/8 drive,

18 mm wrench,

Large flat head screw driver,

Small flat head screw driver,

Ratchet extensions totaling in length 4 feet,

Flashlight,

Container to collect transmission fluid,

2'x 8' block of wood 1 foot long,

Transmission Jack or another person,

Wheel Chocks,

Large Jack,

2 Jack Stands.


****Mechanic Shorcut*****

1. Chock the wheels, jack car up as high as you can, put jack stands in the front. disconnect the battery, remove the starter.

2. Remove the motor mounts bolts from the bottom with 18 mm deep socket.

3. Bring in the transmission jack and raise it so that it takes the weight off the motor and drive line. Strap the transmission to the transmission jack. Use 7/16 socket to remove the 4 drive line bolts. Bring in container to collect transmission fluid when you remove the drive line from output shaft on transmission.

4. Remove transmission mount bolt on cross member beneath tail of transmission with 15mm socket.

5. Use 18 mm wrench and 18 mm socket to remove the nuts and bolts going through the cross member and frame. There are 4 sets of nuts and bolts.

6. Use 15 mm socket to remove the bolts holding the cross member up. There are 8 total, 4 on each side.

7. Use 15 mm socket and extensions to remove 3 exhaust pipes to manifold bolts and 2 exhaust pipes to muffler bolts.

8. Use 15 mm socket to remove the 3 flywheel to torque converter bolts.

9. Use 15mm socket to remove the transmission to motor bolts.

If the transmission does not release on its own, simply inset the large screw driver between the motor and transmission and pry it apart. Be very careful not to land the transmission on your head.

10. Use the small screw driver to remove the transmission line clips, unplug the connections, and your done.

Do not forget...There Is nothing holding that torque converter up. Be gentle and careful when separating the engine and transmission. You want to make sure that the tail housing stays below the bell housing. Otherwise the torque converter will come sliding off

Installation is the reverse of removal.

Comments